3.Be sure that the Uprights (1) are oriented as shown; the high side of the weight rests must be on the indicated side. Attach the Frame (2) to the Crossbar (3) with two M8 x 55mm Bolts (14), two M8 Washers (12), and two M8 Nylon Locknuts (13). Do not tighten the Nylon Locknuts yet.
4.Tap a 30mm Square Inner Cap (22) into each end of the Leg Lever (4).
Tap a 25mm Round Inner Cap (24) into the indi- cated end of the weight tube. Tap the 25mm Angled Round Cap (20) onto the other end of the weight tube.
5.Lubricate the M10 x 60mm Bolt (18). Attach the Leg Lever (4) to the Frame (2) with the Bolt and the M10 Nylon Locknut (19). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot easily.
6.Tap two 19mm Round Inner Caps (9) into each Pad Tube (10). Insert the Pad Tubes into the holes in the Leg Lever (4). Slide two Foam Pads (23) onto each Pad Tube.
3 |
|
|
| High Side of |
|
|
|
| Weight Rests |
| 1 |
|
|
|
|
|
| 1 |
|
|
| 12 | 14 |
|
| 13 |
|
| 12 |
| 2 | 13 | 3 |
|
|
|
| ||
4 |
|
|
|
|
|
|
|
| 4 |
| 22 |
|
| 20 |
|
|
|
| |
| 24 |
|
|
|
| Weight |
| 22 | |
| Tube |
|
| |
5 | 18 | Lubricate |
| |
|
| |||
|
|
|
| 2 |
| 4 |
| 19 |
|
|
|
|
| |
6 |
|
|
|
|
| 23 |
|
|
|
| 4 |
|
|
|
|
|
| 9 | 10 |
|
|
|
| |
|
|
|
| 9 |
|
|
|
| 23 |
|
|
| 10 |
|
6