3.Attach the Bottom Crossbar (15) to an Upright Base (3) with two M10 x 68mm Bolts (23) and two M10 Nylon Locknuts (19). Note: Attach the
Bottom Crossbar so that the indicated decal is in the indicated location. Do not tighten the Nylon Locknuts yet.
Attach the Bottom Crossbar (15) to the other Upright Base (3) in the same manner.
4.Attach an Angled Support (7) to a Stabilizer (5) with an M10 x 68mm Bolt (23) and an M10 Nylon Locknut (19). Attach the Angled Support to the Upright Base (3) with another M10 x 68mm Bolt and an M10 Nylon Locknut. Do not tighten the
Nylon Locknuts yet.
Attach the other Angled Support (7) to the other Stabilizer (5) and Upright Base (3) in the same manner.
5.Press a Rubber Endcap (14) onto the end of an Upright (2). Orient the Upright as shown and attach it to an Upright Base (3) with two M10 x 19mm Bolts (22) and two M10 Washers (18).
Note: The Bolts must be attached to the low- est set of holes in the Upright and Upright Base. Do not tighten the Bolts yet.
Attach the other Upright (2) to the other Upright Base (3) in the same manner. Note: Attach the
Uprights so that the name and
3 |
|
|
|
| 3 |
|
| 23 |
|
| 15 |
|
| |
19 |
| Decal |
| 23 | |
|
| |
|
| 3 |
4 |
|
|
| 23 | 23 |
|
| |
7 |
|
|
| 19 |
|
19 |
|
|
|
| 5 |
|
| 3 |
5 |
|
|
| 2 | 14 |
|
| |
Name |
| |
| Decal | |
Decal |
| |
|
| |
22 |
| 18 |
18 |
| 22 |
| 3 |
|
7