Weider 15CT user manual Adjustments, Attaching the Accessories to a Pulley Station

Page 14

32.Insert the two Locking Pins (53) into the Butterfly Frame (9). Attach the tether on the Pins to the Butterfly Frame with the M4 x 10mm Screw (68).

32

53

68

53

9

33.Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in ADJUSTMENTS, below.

Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 17 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables; see TIGHTENING THE CABLES on page 15.

ADJUSTMENTS

This section explains how to adjust the weight system. See the EXERCISE GUIDELINES on page 18 for impor- tant information about how to get the most benefit from your exercise program. Also, refer to the accompanying exercise guide to see the correct form for each exercise.

Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immediate- ly. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.

ATTACHING THE ACCESSORIES TO A PULLEY STATION

Attach the Lat Bar (42) to the High Cable (45) with a Cable Clip (52). For some exercises, the Chain (not shown) should be attached between the Lat Bar and the High Cable with two Cable Clips. Adjust the length of the Chain between the Lat Bar and the Short Cable so the Lat Bar is in the correct start- ing position for the exercise to be performed.

The Handle (not shown) can be attached in the same manner. The accessories can be attached to the Low Cable (not shown) in the same manner.

45

52

42

14

Image 14
Contents Customer HOT Line QUESTIONS?Model No. WESY17012 Serial No Table of Contents Important Precautions Before YOU Begin For your benefit, read this manual carefully beforeMake Things Easier for Yourself AssemblyFrame Assembly Do not tighten the M10 Nylon Locknuts 71 yet ARM Assembly Tighten the M10 Nylon Locknuts 71 used in stepsLocknut the Pivot Bracket must be able to pivot easily Repeat this step with the Left Butterfly ArmCable Assembly Page Page Page Seat Assembly Adjustments Attaching the Accessories to a Pulley StationConverting the Butterfly Arms Adding Weights to the Weight CarriageTightening the Cables Weight Resistance Chart Weight Press ARM Butterfly LOW Pulley LEG Lever High PulleyCable Diagrams Butterfly Cable High Cable Low CableExercise Guidelines Cooling Down Staying MotivatedPart Identification CHART-Model No. WESY17012 R1203A Page Part LIST-Model No. WESY17012 Qty DescriptionExploded WESY17012Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty