3.Attach the Rear Upright (7) to the Rear Base (3) with the two indicated M10 x 65mm Carriage Bolts (57) and two M10 Nylon Locknuts (71).
Press a 38mm Square Inner Cap (41) into the tube on the Front Upright (6).
Attach the Front Upright (6) to the Front Base (1) with the two indicated M10 x 65mm Carriage Bolts (57) and two M10 Nylon Locknuts (71).
Do not tighten the M10 Nylon Locknuts (71) yet.
4.Press a 50mm Square Inner Cap (22) into the Seat Upright (73). Attach the Bumper (25) to the Seat Upright with an M4 x 20mm Screw (77) and an M5 Washer (75).
Attach the Seat Upright (73) to the Front Base (1) with the two indicated M10 x 65mm Carriage Bolts (57) and two M10 Nylon Locknuts (71). Do not tighten the Nylon Locknuts yet.
5.Make sure there is a Carriage Bushing (32) inside the top of the Carriage Stop (31). Slide the Carriage Stop onto the Rear Upright (7) and attach it at the indicated hole (see the inset draw- ing) with an M8 x 70mm Bolt (72) and an M8 Nylon Locknut (70).
Make sure there are two Carriage Bushing (32) inside the top and bottom of the Weight Carriage (14). Press two 25mm Round Inner Caps (33) into the ends of the tube on the Weight Carriage. Insert an M10 x 20mm Bolt (67) into the bracket on the Weight Carriage.
Slide the Weight Carriage (14) onto the Rear Upright (7). Press a 50mm Square Inner Cap (22) onto the top of the Rear Upright.
3 |
|
|
|
41 |
|
|
|
|
|
| 7 |
6 |
|
|
|
| 71 |
| 71 |
|
|
| |
| 3 |
|
|
71 |
|
| 57 |
|
|
| |
1 |
|
|
|
| 57 |
|
|
4 |
|
|
|
| 22 |
|
|
25 | 73 |
|
|
|
|
| |
77 | 71 |
|
|
|
|
| |
75 |
|
|
|
71 |
| 1 |
|
|
|
| |
| 57 |
|
|
5 | 32 |
|
|
|
|
| |
33 |
| 67 |
|
|
|
| |
| 72 | 14 | 33 |
|
| ||
|
|
| |
7 |
| 32 |
|
Hole | 31 | 70 |
|
22 |
| ||
|
|
| |
|
| 7 |
|
6