ASSEMBLY
Make Things Easier for Yourself
Everything in this manual is designed to ensure that the resistance system can be assembled successfully by almost anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
To hire an authorized service technician to assemble the resistance system, call
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•Because of its weight and size, the resistance system should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the resistance system as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•For help identifying small parts, use the PART IDENTIFICATION CHART.
•As you assemble the resistance system, make sure all parts are oriented as shown in the draw- ings.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
The included hex key(s) 
and grease, and the following tools (not included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.
Before beginning assembly, make sure you understand the information in the box above. For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
Attach three Plastic Feet (1) to the Base (2) with three M4 x 16mm Screws (61).
Attach the Upright Base (5) to the Base (2) with two M10 x 60mm Button Bolts (67), two M10 Washers (59), two M10 x 102mm Button Bolts (65), and four M10 Nylon Locknuts (56).
1 |
|
| |
|
| 5 | |
| 56 | 65 | |
|
| ||
1 | 56 | 56 | |
2 | |||
| |||
61 |
| 1 | |
|
| 61 | |
|
| 1 | |
|
| 61 | |
|
| 59 | |
|
| 67 | |
6 |
|
|