Weider WESY2966.0 user manual Ance system is tipped forward as shown

7.	Note: This step may be easier if the resist-	7
	ance system is tipped forward as shown.
	Route the Long Cable (42) around a 90mm			89
	Pulley (38). Attach the Pulley, a Half Guard	Slot
	(37), a Cable Trap (39), an M10 Washer (59),				37
	and another Half Guard to the Rear Frame (10)
					39
	with an M10 x 52mm Patch Screw (89). Do not
				38
	fully tighten the Button Bolt. Make sure the
		10 42			59
	90mm Pulley is inserted into the indicated
	slot in the Rear Frame. Make sure that the		37
	Cable Trap is oriented to hold the Cable in
	the groove of the Pulley.
8.	Wrap the Long Cable (42) under a 90mm	8
	Pulley (38). Attach the Pulley, a Cable Trap
	(39), and two Half Guards (37) to the Base (2)
	with an M10 x 52mm Patch Screw (89) and an
	M10 Washer (59). Make sure that the Cable	42
	Trap is oriented to hold the Cable in the			59
	groove of the Pulley.
			39			89
		37
					37
				38
			2
9.	Attach a Pulley Bracket (17) to the indicated	9
	“U”-channel (18) with an M10 x 132mm Button
	Bolt (72), two M10 Washers (59), and an M10
	Nylon Locknut (56).
	Wrap the Long Cable (42) over a 90mm Pulley	56			18
	(38). Attach the Pulley inside the Pulley Bracket		59
					56
	(17) with an M10 x 42mm Button Bolt (71) and
		71
					59
	an M10 Nylon Locknut (56).
						72
		42		17
		38
10.	Wrap the Long Cable (42) under a 90mm	10
	Pulley (38). Attach the Pulley, a Cable Trap
	(39), and two Half Guards (37) to the Base (2)
	with an M10 x 52mm Patch Screw (89) and an
	M10 Washer (59). Make sure that the Cable
	Trap is oriented to hold the Cable in the			42	37	89
	groove of the Pulley.
	Note: The Half Guards (37) attached in this		37
	step will overlap the Half Guards attached in				59
	step 8.
				39 38
		2
		9