HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
• Clean the filter when water leaks from the water inlet.
1Pull the power plug out before cleaning it.
2Turn off the water supply to the washer and separate the inlet hose. 
3Pull the inlet filter out.
4Remove the dirt from the inlet filter with a brush.
Cleaning the drain filter
•This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
•If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be caused.
CAUTION : Be careful when draining if the water is hot.
1.Open the lower cover(1) by using a coin. Remove the cap hose(2) to pull out the hose.
100
1
2.Unplug the cap hose(2), allowing the water to flow out. At this time use a vessel to prevent water flowing on to the floor. When water does not flow any more, turn the pump filter(3) open to the left.
23
3.Remove any foreign material from the pump filter(3). After cleaning, turn the pump filter clockwise and insert the cap hose(2) to the original place. Close the lower cover.
3
2
Cleaning the detergent case
*After a while detergent and fabric softeners leave a deposit in the case;
-It should be cleaned from time to time with a jet of running water.
-If necessary it can be removed completely from the machine by pressing the catch downwards and by pulling it out.
-To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
*Detergent can also accumulate inside the recess which should be cleaned occasionally with a brush.
*Once you have finished cleaning, replace the case and run a rinse cycle without laundry.
20