5.18 Cancelling the programme
Press and hold the Start / Pause / Cancel button for 3 seconds. The Start symbol flashes. The symbol of the step at which the programme was cancelled remains lit. "End" appears on the display and the programme is cancelled.
To open the loading door after you have cancelled a programme and the water level in the machine is above the loading door opening, first turn the Programme Selection knob to the Pump+Spin programme and discharge the water in the machine.
5.19 Machine is in Rinse Hold mode
The Spin symbol flashes and the Pause symbol illuminates when the machine is in Rinse Hold mode.
If you want to spin your laundry when the machine is in this mode:
Adjust the spin speed and press the Start / Pause / Cancel button. The Pause symbol disappears and the Start symbol appears. The programme resumes, discharges the water and spins the laundry.
If you only want to drain the water without spinning:
Press the Start / Pause / Cancel button. The Pause symbol disappears. The Start symbol appears. The programme resumes and discharges the water only.
5.20 End of programme
“End” appears on the display at the end of the programme. The symbols of the programme steps remain lit. The auxiliary function, spin speed and temperature that were selected at the beginning of the programme remain selected.
PAGE 18
6 Maintenance and cleaning
The service life of the machine can be extended if it is cleaned at regular intervals. Regular cleaning also helps to alleviate possible problems.
6.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 45 washing cycles) as shown below in order to prevent the accumulation of powder detergent over time.
1.Press the dotted point on the siphon in the softener compartment and pull it towards yourself until the compartment is removed from the machine.
If an excess amount of water and softener mixture starts to accumulate in the softener compartment, the siphon must be cleaned.
2.Wash the detergent drawer and the siphon with plenty of lukewarm water in a wash basin. Wear protective gloves or use an appropriate brush to avoid skin contact with the residues in the drawer whilst cleaning.
3.Insert the drawer back into its place after cleaning and make sure that it is properly seated.
The detergent drawer of models in the range may differ.
Lift the rear part of the siphon to remove it as illustrated. After performing the above mentioned cleaning procedures, replace the siphon back into its seating and push its front section downwards and ensure that the locking tab engages.