3.4 Connecting the water supply
1.Connect the special hoses supplied with the product to the water inlets on the product. Red hose (left) (max. 90 ºC) is for hot water inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
Warning: Ensure that the cold and hot water connections are made correctly when installing the product, to prevent your laundry from coming out hot at the end of the washing process resulting in undue wear.
2.Tighten all hose nuts by hand. Never use a tool when tightening the nuts.
3.Open the taps completely after finishing the hose connection and check for water leaks. If there are any leaks, turn off the tap and remove the nut. Retighten the nut carefully after checking the seal. To prevent water leakages and damages caused by them, keep the taps closed when the machine is not in use.
3.5 Connecting to the drain
•The end of the drain hose must be directly connected to the wastewater drain or to the washbasin.
Warning: Ensure that the end of the discharge hose is securely fixed into its housing to ensure the smooth flow of water and to avoid any risk of flooding and injury from hot water.
The hose should be attached to a height of at least 40 cm, and 100 cm at the most.
•Incorrect hose height results in water discharge from the machine being more difficult and the laundry may come out excessively wet.
Ensure that the heights in the figure are followed.
To prevent flowing of dirty water back into the machine and to allow for easy discharge, do not immerse the hose end into dirty water and do not insert it more than 15 cm into the drain. If it is too long, carefully cut it shorter.
•The hose should not be twisted, bent or squeezed shut and must not be stepped on.
•If the length of the hose is too short, add an original extension hose. The length of the hose may not be longer than 3.2 m. To avoid water leaks, the connection between the extension hose and the drain hose of the product must be securely fitted with an appropriate clamp.
3.6 Adjusting the feet
Warning: To ensure that the machine operates efficiently and vibrationfree, it must be level on its feet. Level the machine by adjusting the feet. Failure to level and balance the machine may result in machine movement and vibration problems.
1.Loosen the lock nuts on the feet by hand.
2.Adjust the feet until the machine stands level and balanced.
3.Tighten all lock nuts again by hand.
PAGE 5