Connect to a drainage system
●Do not remove hooked end support from drainage hose.
●Do not position standpipe near an electrical outlet.
For drainage into a standard work top sink ensure outlet pipe has a minimum bore of
32 mm. To avoid syphoning ensure the end of the drainage hose is above the water level in the sink. If your sink is inset, the front edge of the basin must be less than 75 mm from the front edge of your work top.
We recommend one of the following methods:-
Into a Standpipe
Ensure the standpipe has a minimum bore of 38mm (11⁄2”).
1. Ensure the top of the standpipe is at least 500mm (20”) from the floor.
2. Untie GREY drainage hose and place approximately 100mm (4”) into the standpipe.
3.If the end of your GREY drainage hose is fitted with ‘Retaining Flaps’ ensure they are fully inserted into the standpipe as shown (Fig. 2)
500 mm
Fig 1
Fig 2
Into a Sink Waste System | Fig 3 |
Ensure the sink outlet pipe has a minimum diameter of 32mm (11⁄4”).
1.Untie drainage hose from rear of the appliance.
2.Reposition the Hooked End Support as required along the GREY drainage hose.
3.If fitting an under sink waste disposal unit (Fig 3), cut out the membrane or blanking plug.
4.Attach the end of the GREY drainage hose to the undersink waste disposal securely as shown using a hose clip (Fig 4).
Cut
5. Raise the hose to a minimum height of 800 mm to avoid syphoning.
Fig 4
Hose Clip
4