Connections and installation
Connecting to an Audio Mixer (not included)
•Disconnect all units from the power source before making any con- nections.
•Reconnect the AC power supply cord after all other connections
are complete. | Unit |
Unit | |
| Earth lead |
Audio mixer
Installation
•Install the unit on a horizontal surface protected from vibrations.
•Keep this unit as far as possible from speakers.
•Ensure the unit is not exposed to direct sunlight, dust, humidity, and heat from a heating appliance.
•This unit may pick up interference from a radio if there is one nearby. Keep radios as far as possible from this unit.
Adjusting the height of the insulators
Place the unit where it is to be used and adjust the height of the legs to make the unit horizontal. 
Preparatory adjustments
Horizontal balance and stylus pressure
1Release the tone arm.
1.Remove the stylus cover, taking care not to dam- age the stylus, then release the arm clamp.
2.Free the tone arm from the arm rest.
Arm clamp
3Turn the stylus pressure control to “0”
1.Return the tone arm to the arm rest and fix it with the arm clamp.
2.Turn the stylus pressure control to “0”.
Hold the balance weight still while doing this.
Balance weight
2Adjust horizontal balance
1.Push the cue lever down.
2.Turn the
3.Turn the balance weight until the arm is approxi- mately horizontal.
Take care at this time not to allow the stylus to touch the unit.
Balanced
Center line
Arm clamp
Turn stylus pressure
control
Too far forward
Too far back
Arm clamp
Arm rest
Cue lever
6
4Adjust stylus pressure
Turn the balance weight to adjust to the appropri- ate pressure for the cartridge you are using.
See the cartridge’s instructions for recommended stylus pres- sure.
The stylus pressure control will turn at the same time. Stop when the center line points to the required pressure.
Turn balance weight
Center line
RQT7018