Electrolux 74335 manual Follow instructions for Washing is heavily

		Operating Instructions
Problem	Possible Cause	Solution
		Follow instructions for the
Washing is heavily	Probably too much washing	maximum load quantity (see
		Program Tables). For easy-
creased.	was put in the drum.
		care fabrics select the EASY
		IRON program.
	Drain hose is kinked.	Remove the kink.
		Contact your local Service
	Maximum pump head (outlet	Force Centre; a conversion
Washing has not been	head 1m from unit's floor	kit is available as a special
	surface) exceeded.	accessory for pump heads
spun properly. Water is
		over 1m.
left in the drum.
RINSE display is flash-		Switch off the appliance and
ing.
	Drain pump is blocked.	pull out the mains plug.
		Clean the drain pump.
	If siphon is connected:	Clean the siphon.
	siphon blocked.
		Wait until the green DOOR
		display lights up.
		Should it still be necessary to
	The door is locked due to a	open the door:
	high water level or a high	turn the program selector to
	temperature. (The DOOR dis-	OFF turn the program selec-
	play is off).	tor to PUMP OUT. Press
		START/PAUSE button.
The door cannot be		After the water has been
opened when the		pumped out, the door can be
appliance is switched		opened.
on.
		If water can be seen through
		the window in the door, first
	Power failure! (All displays	carry out emergency empty-
	have gone off.)	ing (see section “Carrying out
	For safety reasons the door	Emergency Emptying Opera-
	remains locked for 4 to 5	tion").
	minutes.	After approx. 4 to 5 minutes
		the door can be opened
		again by pulling the handle.

31