Operating Instructions
Washing cycle is complete/Removing Washing
A wash program normally ends with the final spin.
If SOAKING has been selected:
0Release the SOAKING button (main wash for COTTONS/LINEN or EASY- CARES will run).
If RINSE HOLD has been selected:
The water must first be pumped out or the washing must still be spun.
0Either release the RINSE HOLD button
(water is pumped out and the washing spun according to the program that has been run; the spin speed can still be changed even during the spin),
or
turn the program selector clockwise to PUMP OUT (water will be pumped out without spinning),
or
turn the program selector clockwise to SPIN
(water will be pumped out and the washing spun at the set speed; the spin speed can still be changed even during the spin).
Once the program is completed:
3 | For safety reasons, the door remains locked for |
| end of the program. |
0 1. Open the door.
2.Remove the washing.
3.Press ON/OFF button. The power indicator light will go out. The washing machine has been switched off.
4.Turn off the water tap.
5.Pull the washing detergent disperser drawer out slightly to allow it to dry. Leave the door ajar so that air can circulate in the drum.
Important! If the washing machine is not to be used for a long period: Close the water tap and disconnect the washing machine from the electricity mains.
23