Electrolux 50630 manual Clean the detergent dis

		Operating Instructions
Problem	Possible Cause	Remedy
Fabric softener was not	The conditioner insert has
washed into machine;		Clean the detergent dis-
	not been correctly positioned
drawer æ for condi-		penser drawer and attach the
	inside the conditioner com-
tioner is filled with		conditioner insert securely.
	partment or is blocked.
water.
		Pay attention to the maxi-
Washing is heavily	Probably too much washing	mum load quantity (see Pro-
		gram tables). In the case of
creased	was put into the drum.
		easy-care fabrics, select the
		EASY IRON program.
	Drain hose is kinked.	Remove the kink.
		Contact your local Service
	Maximum pump head (dis-	Force Centre. For pumping
Washing has not been	charge height 1 m from the	heights over 1 m a conver-
spun properly. Water is	appliance’s base) is exceeded.	sion kit is available as a spe-
left in the drum.		cial accessory.
		Switch off the appliance and
	Drain pump is blocked.	pull out the mains plug.
		Clean the drain pump.
Remnants of detergent	Water tap is not fully open.	Open the water tap fully.
		Close the water tap. Unscrew
are building up in the	The inlet hose filter in the
detergent dispenser		the inlet hose from the water
	coupling inlet hose at the
drawer.		tap and from the appliance.
	tap is blocked.
		Clean the filter.
The rinsing water is	The cause is probably a	No negative effect on the
	detergent with a high silicate	rinse results; use a liquid
cloudy.
	content.	detergent if necessary.
Door cannot be	Door is locked for safety rea-	Wait for 1 or 2 minutes after
opened.	sons.	the end of the program.

31