Electrolux 50630 manual Not been removed

Operating Instructions

Problem	Possible Cause	Remedy
	The transport packaging has	Remove transport packaging
		according to the installation
	not been removed.
		and connection instructions.
		Adjust the feet according to
	The machine is not level.	the installation and connec-
		tion instructions.
The washing machine	There is very little washing in	This does not impair the
vibrates during opera-
	the drum (e.g. only one
tion or is unstable.		function.
	dressing gown).
	The water could not be com-	Check the drain hose and
		remove any kink if necessary,
	pletely pumped out before	or clean the drain pump and,
	spinning because
		if required, remove foreign
	the drain hose is kinked or
		bodies from the pump hous-
	the drain pump is blocked.
		ing.
	The screw connection on the	Tighten the inlet hose screw
	inlet hose is leaking.	connection
	The drainage hose is leaking.	Check the drainage hose and
		replace it if necessary.
	The drain pump cover is not	Close cover correctly.
	correctly closed.
Water runs out from		Stop the program and
	Washing is caught in the	remove the washing caught
under the washing
	door.	in the door. Restart the pro-
machine.
		gram.
		Seal the emergency empty-
		ing hose correctly (see sec-
	The emergency emptying	tion “Carrying Out an
	hose is not correctly sealed	Emergency Emptying“). Call
	or is leaking.	your local AEG Service Force
		Centre if the emergency
		emptying hose leaks.
	RINSE HOLD has been	Cancel RINSE HOLD.
The washing machine	selected.
does not spin; there is	Soaking program has fin-	Release SOAKING button
water in the drum.
		(main wash program will fol-
	ished.
		low).

30