Oki 4410 manual Error Messages, Problem, Solution

Problem:

I’m trying to print envelopes, but they keep jamming.

Solution:

If you load continuous-form envelopes at the default position, the auto gap thickness is sensed at the envelope’s flap position which is thinner than the envelope’s main area. This can cause jamming when the envelopes are being printed.

The auto gap needs to be set at the thicker area of the envelope. To do this:

1.Press FF/LOAD to load the envelope forms into the print path.

2.Hold SHIFT and press FF/LOAD/Micro Feed Up until the bail closes.

3.Press PARK to remove the envelopes from the print path.

4.Press FF/LOAD.

5.Send one address to start the printhead moving so that the gap is automatically set for the double thickness area of the envelope.

6.Press PARK to remove the envelopes from the print path.

7.Hold SHIFT and press PATH/TOF to reset the Top of Form to the factory setting.

8.Press FF/LOAD to load the envelopes back into the print path.

Error Messages

Error Message	What to Do
AUTO GAP	Printhead gap malfunction. Try turning the printer off, then on
	again. If message persists, contact your service provider (see
	Section 4).
BAIL	Bail motor not functioning properly. Try turning the printer off,
	then on again. If message persists, contact your service provider
	(see Section 4).
CENTERING	Spacing error during centering operation. Try turning the printer
	off, then on again. If message persists, contact your service
	provider (see Section 4).
CG-ROM	Try turning the printer off, then on again. If message persists,
	contact your service provider (see Section 4).
COVER OPEN	Printhead access cover is open. Close it.
D-RAM	Try turning the printer off, then on again. If message persists,
	contact your service provider (see Section 4).

34