Oki 4410 manual Caution! If the page width is set, narrower than the continuous forms

Item	Description	Emulations	Group(s)
Page Width	Change to 8" if you are using 9-inch	All	Rear Feed,
	continuous forms. For continuous forms		Front Feed
	less than 9 inches wide, the page width
	must be set using software.
	Caution! If the page width is set
	narrower than the continuous forms
	being used, the printhead will print
	directly on the platen: this can
	damage the printhead.
Parity	Sets the type of parity your system uses.	All	Serial I/F
Pin 18	Sets the signal on pin 18 of the parallel	All	Parallel I/F
	interface to +5 volts or to open.
Pitch	Sets the character width in characters	All	Font
	per inch.
Ppr Out Override	Paper Out Override: Senses when less	All	Set-Up
	than 1" (25 mm) of paper remains and
	stops printing. Change to Yes to override
	the sensor. Caution!! This can cause loss
	of data and damage the printhead!
Print DEL Code	Change to Yes if you wish to print the DEL	ML only	Set-Up
	code (decimal 27) as a solid box.
Print Mode	Sets the typeface used: Utility, NLQ	All	Font
	(Near letter Quality) Courier, NLQ
	(Near Letter Quality) Gothic, or
	HSD (High Speed Draft).
Print Suppress	If you wish to enable the print suppress	All	Set-Up
	command, change the setting to Yes. If
	you select Yes, the printer will ignore all
	data after it receives the print suppress
	command.
Prop. Spacing	Change to yes if you wish to engage	All	Font
	proportionally spaced printing.
Protocol	Switch to X-ON/X-OFF if that is the	All	Serial I/F
	serial interface protocol you are using.
Rcv. Buffer	Sets the size of the receive buffer.	All	Set-Up

20