Oki 4410 manual Error Message, What to Do

Error Message	What to Do
OKI HSP CONNECT	There is a problem with the OKI HSP connection. Check to be
	sure that the print server is properly installed and that the
	connection is secure. If message persists, contact your service
	provider (see Section 4).
OPT CARD ROM	There is a problem with the ROM on the optional interface card.
	Try turning the printer off, then on again. If message persists,
	contact your service provider (see Section 4).
OPT CARD CONNECT	There is a problem with the connection to the optional interface
	card. Check to make sure that the card is properly installed and
	that the connection is firm, then try turning the printer off, then
	on again. If message persists, contact your service provider (see
	Section 4).
OPTICAL SENSOR	Paper width sensor alarm. Try turning the printer off, then on
	again. If message persists, contact your service provider (see
	Section 4).
PAPER END	Paper has run out. Load a new stack of continuous forms.
PAPER JAM	Paper edge has ripped and caused a jam. Clear the paper jam
	(see Section 2) and reload paper.
PAPER RELEASE	The bail is partially open. Press SHIFT + PARK.
PARK JAM	Paper jammed as it was being parked. Clear the paper jam (see
	Section 2) and reload paper.
PATH CHANGE	Path switching motor is not functioning properly. Contact your
	service provider (see Section 4).
PATH CHANGE JAM	Paper jam during change in paper path.
	* 1. Check to be sure that paper is loaded in both paths.
	* 2. Determine which path is jammed, then clear the jam and
	reload paper.
POWER FAN	Power supply fan malfunction. Contact your service provider
	(see Section 4).
PROGRAM-ROM	Try turning the printer off, then on again. If message persists,
	contact your service provider (see Section 4).
RIBBON	Ribbon motor not functioning properly . Try turning the printer
	off, then on again. If message persists, contact your service
	provider (see Section 4).

36