Oki 4410 manual Description Emulations Groups

Item	Description	Emulations	Group(s)
Data Word Size	If your computer system uses seven bits	ML only	Set-Up
	to make up each unit of data, change this
	setting to 7.
Default Path	Change to Rear Path or Front Path if you	All	Set-Up
	wish the printer to use that paper path
	as its default.
Diagnostic Test	Change to Yes if you want to perform a	All	Serial I/F
	diagnostic test of the serial interface
	(see Appendix B: Interfacing).
DSR Signal	Used with Ready/Busy protocol (factory	All	Serial I/F
	setting) to determine the way your system
	handles the DSR (Data Set Ready) signal.
DTR Signal	Change to Ready on Select if the DTR	All	Serial I/F
	(Data Terminal Ready) signal is required
	when the printer is selected; leave as
	Ready on Power Up if the DTR signal is
	required when the printer is turned on.
Emulation Mode	Sets the printer emulation.	Not	Printer
		applicable	Control
ESC SI Pitch	Sets the character pitch used when the	IBM only	Set-Up
	ESC SI command is received by the
	printer.
Form Tear-Off	Select 500 ms, 1 second, or 2 seconds to	All	Rear Feed,
	turn the Form Tear-Off feature on and to		Front Feed
	set the time interval for the printer to wait
	before advancing the paper to the tear-off
	position.
Graphics	Change to uni-directional printing to	All	Set-Up
	improve alignment between print lines
	when printing graphics. This will slow
	down the printing. Alternately, you can
	leave Bi-directional enabled and optimize
	graphics printing by adjusting the print
	registration setting in the Set-Up group.

18