Installation
Unpacking
All transit bolts and packing must be removed before using the appliance.
7.Pull out the three plastic spacers from the holes into which the bolts were fitted.
8.Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet.
ENGLISH
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.
1.Using a spanner, unscrew and remove the rear
P0256 |
P0020 |
2.Remove the polystyrene block from the bottom of the machine and release the two plastic bags.
3.Carefully remove the
4.Unscrew and remove the feet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.
Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.
P1065 |
2 | 1 |
P1066 |
|
Water inlet
5.Fit the grid (A) on the bottom of the machine using the four screws (B) you will find in the bag containing the instruction booklet.
B |
B |
Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread.
Do not use already employed hoses.
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks.
A |
B |
B |
P1067 |
6.Set the machine upright and remove the two remaining bolts from the back.
P1088 |
5 |
P0021 |