Electrolux AW 1402 W Operating sequence, Load the laundry Open the door by carefully pulling

Page 14

Operating sequence

Load the laundry Open the door by carefully pulling the

door handle outwards.

Place the laundry in

the drum, one item at

a time, shaking them out as much as

possible. Close the door.

Measure out the detergent and the fabric softener

Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment and, if you wish to carry out a programme with the prewash, pour it into the compartment marked .

If required, pour fabric softener into the compartment marked (the amount used must not exceed the «MAX» mark in the drawer). Close the drawer gently.

Select the required programme by means of the programme selector dial (1)

Turn the programme selector dial to the required programme.

The green light of button 6 starts to flash. It can be turned either clockwise or anticlockwise.

On position «O» the programme is reset and the machine is switched OFF.

At the end of the programme the selector dial must be turned to position «O», to switch the machine off.

ATTENTION!

If you turn the programme selector dial to another programme when the machine is working, the red pilot light of button 6 will flash 3 times to indicate a wrong selection. The machine will not perform the new selected programme.

Select the required temperature by means of the temperature selector dial (2)

Turn the programme selector dial to the required temperature. It is possible to select a temperature from 90°C to Cold.

For the maximum temperature allowed by each programme, refer to the section «Programmes table».

Select the spin speed or Rinse Hold option by pressing button 3

The relevant light will light up.

When selecting a programme, the light corresponding to the maximum speed allowed for that programme will illuminate (refer to the section «Programme table»).

Select the desired option by means of buttons 4 and 5

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before pressing the button 6.

For the compatibility of the options with the washing programmes, refer to the section

«Programme table».

14

Image 14
Contents User Manual Washing machine Content Thank you for selecting our applianceInstallation Safety informationGeneral safety Child safety UseDescription of the appliance Detergent dispenser drawerSymbols Control panel and functionsOptions Button FunctionsRinse Hold Button Extra Rinse ButtonSynthetic or mixed fabrics Delicate items Programme tableWhite coloured cotton normally soiled cotton items Economy Description Programme Programme information Jeans Sport Intensive Rinse Drain SpinWashing hints Detergents and additives Degrees of water hardness Before the first useQuantity of detergent to be used Measure out the detergent and the fabric softener Operating sequenceLoad the laundry Open the door by carefully pulling Select the desired option by means of buttons 4Start the programme by pressing button Cancelling a programmePay attention to the water level and temperature Altering an option or a running programmeCare and cleaning Cleaning the water inlet filter Emergency emptying outSomething not working Water tap is closed. Red pilot light of button 6 flashesLight of button 6 flashes Malfunction Technical data Consumption values InformationPositioning Installation InstructionsUnpacking Into a drainage standpipe Water inletWater drainage Special conditions Onto a sink outlet spigotLevelling Interest of the environmentElectrical connection Permanent connectionOld machine Environmental concernsPackaging materials Ecological hints132 966 640 00 Subject to change without notice