Water inlet
An inlet hose is supplied and can been found inside the machine drum.
Do not use the hose from your previous machine to connect to the water supply.
1.Open the porthole and extract the inlet hose.
2.Connect the hose with the angled connection to the machine.
Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.
The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.
There should be a minimum vertical distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods.
1. Into a drainage standpipe.
35° | 45° |
|
3.Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.
“U” piece supplied
38 mm (1.5”) standpipe
diameter 
(12") 
cm
4.Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
NOTE
Installation should comply with local water authority and building regulations’ requirements.
30
Firstly form a hook in the end of the drain hose using the «U» piece supplied. Place the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring there is an air break between the drain hose and standpipe.
When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level.
24