Electrolux AW 1202 W, AW 1402 W Onto a sink outlet spigot, Levelling, Special conditions

Page 25

60 cm (23.6”)

Max. 90 cm (35.4”)

Min.

 

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18mm.

If your drain hose looks like this (see below) you do not require the «U» piece. Just push the hose firmly into the standpipe.

2. Onto a sink outlet spigot.

If the outlet spigot has not been used before, remove any blanking plug that may be in place.

Loop

Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine.

Important!

Before connecting the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes.

Levelling

Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable.

Any necessary

adjustment can be

made with a spanner.

Accurate levelling

prevents vibration,

noise and displacement of the

machine during operation.

Some vibration is inevitable, especially if mounted on a wooden floor.

Sprung wooden floors are particularly susceptible to vibration. For advice, consult a builder. If possible, always place the machine on a solid floor.

Special conditions

If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine.

WARNING!

The machine should NOT be placed on deep pile carpeting.

NOTE

Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.

In the interest of the environment

Washing machines and dishwashers should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river. It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution.

25

Image 25
Contents User Manual Washing machine Thank you for selecting our appliance ContentGeneral safety Safety informationInstallation Use Child safetyDetergent dispenser drawer Description of the applianceControl panel and functions SymbolsRinse Hold Button FunctionsOptions Button Extra Rinse ButtonWhite coloured cotton normally soiled cotton items Economy Programme tableSynthetic or mixed fabrics Delicate items Description Programme Jeans Sport Intensive Rinse Drain Spin Programme informationWashing hints Detergents and additives Quantity of detergent to be used Before the first useDegrees of water hardness Load the laundry Open the door by carefully pulling Operating sequenceMeasure out the detergent and the fabric softener Select the desired option by means of buttons 4Pay attention to the water level and temperature Cancelling a programmeStart the programme by pressing button Altering an option or a running programmeCare and cleaning Emergency emptying out Cleaning the water inlet filterWater tap is closed. Red pilot light of button 6 flashes Something not workingLight of button 6 flashes Malfunction Technical data Information Consumption valuesUnpacking Installation InstructionsPositioning Water drainage Water inletInto a drainage standpipe Levelling Onto a sink outlet spigotSpecial conditions Interest of the environmentPermanent connection Electrical connectionPackaging materials Environmental concernsOld machine Ecological hints132 966 640 00 Subject to change without notice