Electrolux FJDR 1666 W, FJDR 1466 S, FJDR 1466 W, FJDR 1266 W manual Water inlet, Water drainage

Page 24

Water inlet

Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance to connect to the water supply.

P1088

Installation should comply with local water authority and building regulations’ requirements.

The appliance must be connected to a cold water supply.

A minimum water pressure of 50 kPa (0.5 bar) is required for safe operation of the appliance.

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

P0021

Water drainage

This appliance is designed to be permanently plumbed into your home's water supply and drainage system.

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece” supplied.

(12")cm

30

P1074

The standpipe should have an internal diameter of approximately 38mm (see diagram) thus ensuring there is an air break between the drain hose and standpipe.

cm.(12")30Min.

38 mm.(1/2") diameter

standpipe

 

P1040

When discharging into a standpipe ensure that the top of the curve in the hose end is no more than 90cm (35.4'') and no less than 60cm (23.6'') above floor level. The upright standpipe should have a minimum length of 30cm (12'') from the bottom of the elbow to the top of the pipe (see diagram).

3 pin

 

90 cm.(35.4")

cm.

Max.

Min.60 (23.6")

P1039

 

Make sure that it is designed in such a way, that the end of the drain hose cannot be covered with water. The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece

is available from your local Service Force Centre.

The joining piece must have an internal diameter of 18mm.

24

Image 24
Contents Washing Machine Installation Child SafetyUse Contents Your New Washing Machine Ecological hintsInterest of the environment Child safety feature Description of the ApplianceDoor locked light Detergent dispenser drawerControl Panel Wash Choice button Options buttonDisplay Drain onlySKIP/RESET button START/PAUSE buttonSelecting a special programme Delay Start button Programme phase indicator lightsOperating Sequence Select the temperature Select the Delay StartSelect the desired options Select the Super Rinse or AA40 optionHow to change a programme during its cycle Start the programmeEnd of programme «JETSYSTEM» wash 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing programmes Maintenance and Cleaning Cleaning the water inlet filter Emergency emptying outSomething Not Working Service & Spare Parts 0870 5Guarantee Conditions Standard guarantee conditionsEuropean guarantee Customer Care DepartmentInstallation Instructions Technical SpecificationsInstallation on a Suspended Floor UnpackingPositioning Water inlet Water drainageAppliance must be connected to a cold water supply Levelling Special conditionsElectrical connection Permanent connectionFrom the Electrolux Group. The world’s No choice