Electrolux FJDR 1466 W, FJDR 1666 W, FJDR 1466 S manual Electrical connection, Permanent connection

Page 26

Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s rating plate. The rating plate is located at the top of the rim of the open door.

 

Mod

 

Prod. No

P0042 BD

Ser. No

 

The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow

- Earth

Blue- Neutral

Brown- Live

GREEN & YELLOW

E

The wire coloured blue must be connected to the terminal marked «N» or coloured black.

The wire coloured brown must be connected to the terminal marked «L» or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

WARNING:

A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard.

Ensure that the cut off plug is disposed of safely.

The power supply cable must be easily accessible after installing the appliance.

Permanent connection

In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

N

13 A

L

BROWN

BLUE

P1041

CORD CLAMP

 

The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow.

26

Image 26
Contents Washing Machine Use InstallationChild Safety Contents Interest of the environment Your New Washing MachineEcological hints Door locked light Child safety featureDescription of the Appliance Detergent dispenser drawerControl Panel Display Wash Choice buttonOptions button Drain onlySelecting a special programme SKIP/RESET buttonSTART/PAUSE button Delay Start button Programme phase indicator lightsOperating Sequence Select the desired options Select the temperatureSelect the Delay Start Select the Super Rinse or AA40 optionEnd of programme How to change a programme during its cycleStart the programme «JETSYSTEM» wash 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing programmes Maintenance and Cleaning Cleaning the water inlet filter Emergency emptying outSomething Not Working Service & Spare Parts 0870 5European guarantee Guarantee ConditionsStandard guarantee conditions Customer Care DepartmentInstallation Instructions Technical SpecificationsPositioning Installation on a Suspended FloorUnpacking Appliance must be connected to a cold water supply Water inletWater drainage Levelling Special conditionsElectrical connection Permanent connectionFrom the Electrolux Group. The world’s No choice