Electrolux LAVAMAT 74810 manual If the wash result is not satisfactory

Problem	Possible cause	Remedy
Fabric softener was not	Fabric softener insert in the
rinsed in, the		Clean the detergent drawer,
	compartment for
compartment w for		insert the fabric softener
	conditioners is not correctly
conditioners is full of		insert firmly.
	attached or is blocked.
water.
		Wait until the DOOR
	Door locked.	indicator is illuminated
		green.
		The programme will continue
The door cannot be		when the power cut is over.
opened when the
	There has been a power cut.	To remove washing:
washing machine is
switched on.	(All the indicator are off).	If water can be seen in the
	The door remains blocked	appliance, first drain off the
	for approx. 4 to 10 minutes.	water before opening the
		loading door (see section
		“Carrying out an emergency
		drain”).
Washing is heavily	Possibly too much washing	Observe maximum loads.
creased.	was loaded.

If the wash result is not satisfactory

The washing is grey and there are limescale deposits in the drum

•Too little detergent was used.

•An incorrect detergent was used.

•Individual stains were not pre-treated.

•The programme or temperature was not set properly.

There are grey stains on the washing

•Items that were soiled with ointments, fats or oils were washed using too little detergent.

•The wash temperature used was too low.

•A common cause is that conditioner – in particular the type in con- centrated form - has come in contact with the washing. Wash out such marks as soon as possible and exercise care when using the said conditioner.

Foam can still be seen following the final rinse

•Modern detergents can cause foam to be created even during the fi- nal rinse. In spite of this, the washing has been sufficiently rinsed.

21