Electrolux 62610 If the wash results are not satisfactory, There are grey stains on the washing

Problem	Possible cause		Remedy
	Door locked.	Wait until	indicator
		(DOOR) is lit green.
		The programme will continue
The door cannot be	There has been a power cut.	when the power cut is over.
opened when the wash-		To remove washing:
ing machine is switched	(All indicators are off.)
on.	For safety reasons, the door	If water can be seen in the
	remains locked for approx. 4	appliance, before opening
	to 10 minutes.	the door, first drain off the
		water. (See section “Carrying
		out an emergency drain”.)
Washing is heavily	Possibly too much washing	Observe maximum loads.
creased.	was loaded.

If the wash results are not satisfactory

Washing is grey and scale is being deposited in the drum

•Too little detergent is being used.

•The right detergent was not used.

•Special soiling was not pre-treated.

•Programme or temperature was not correctly set.

There are grey stains on the washing.

•Washing soiled with ointment, grease or oil was washed with too lit- tle detergent.

•It was washed at too low a temperature.

•A common cause is that fabric conditioner – especially a concentrate

– has got onto the washing. Such stains should be washed out as quickly as possible and make sure that you are careful when using fabric conditioner.

After the last rinse foam can still be seen.

•Modern detergents may create foam even in the last rinse cycle. The washing is however sufficiently rinsed.

There are white residues on the washing.

•This is due to the insoluble ingredients in modern detergents. They are not caused by insufficient rinsing.

Shake or brush the washing. If possible turn the washing inside out before washing. Check your choice of detergent. Especially with dark colours it is advisable to use liquid detergents.

20