Electrolux 62610 manual Making the appliance level, If the appliance is to stand on a plinth

•The surface on which the appliance is to be installed must be clean and dry and free from coverings that move, so that the appliance does not slide.

•If the location in which the appliance is to be installed is fitted with small-format tiles, put a rubber mat (available in the shops) under the appliance.

If the appliance is to stand on a plinth:

In order for the appliance to be se- cure on the plinth, fixing plates*) must be mounted, into which the appliance is inserted.

If the appliance is to stand on floors that vibrate, e. g. floors of wooden joists with deal boards:

If possible, install the appliance in one corner of the room.

1.Screw a water-resistant wooden board (at least 15 mm thick) onto at least 2 of the floor joists.

2.Affix fixing plates *) onto the wooden board, into which the appliance is inserted.

*) The fixing plates can be obtained from the Customer Care Depart- ment.

Making the appliance level

The four feet of the appliance are pre-adjusted.

Large degrees of unevenness can be compensated for by individually ad- justing the height adjustable screw feet.

Use the special spanner supplied to do this.

Important! Do not use pieces of wood, cardboard or such like to lev- el out unevenness in the floor, but adjust the height adjustable screw feet instead.

28