Engine Oil, Stopping Your Pressure Washer

attempt to operate equipment until you have

read Owners Manual for Safety, Operation, and _, ARNING: Read Owner's Manual. Do not

Maintenance Instructions.

Note: included with your unit is a video cassette that demonstrates how to operate your pressure washer. If you have a video cassette recorder you should view the video before operation.

& WARNING: Never adjust spray pattern when

Before Starting The Engine

To operate the engine you will need to do the following,

• , CAUTION: Always check engine oil level	I
before every start. Running engine low of oil or
out of oil could result in serious damage.

Engine Oil

bottle of SAE 30 weight oil is included in the carton.

spraying. Never put hands in front of spray nozzle to adjust spray pattern you could be injured.

Stopping Your Pressure Washer

Remove oil dip stick located on top of the engine, Oil Yourcapacityunit ishasaboutbeen20shippedounceswithoutof oil. Theoil oilin thedip enginestick is. A clearly marked w{th a line that tells you when unit has enough oil. To check oil, place dipstick into oil fill. Tighten dipstick then remove. Do not fill above this

A CAUTION: Do not run pump without the water supply connected and turned on. Failure to do so will result in pump damage.

•Move throttle control to the stop position to turn pressure washer off.

THROTTLE

CONTROL

Simply shutting OFF engine will not release pres- sure in the system. After engine has stopped, squeeze the trigger on the spray gun for about 3 seconds to relieve pressure. Spray stream will decrease in length.

IMPORTANT: This unit is equipped with a thermal relief valve. If unit is allowed to run for several minutes without pressing the trigger on the spray gun, several drops of water may be released through this valve to cool the unit. This small amount of water will drip from the bottom of the pump.

point. Pour slowly.

NOTE: When adding oil to the engine crankcase, use a high quality detergent oil classified "For Service SF, SG, SH", rated SAE 30 weight. Use no special addi- tives. Select the oil'sviscosity grade according to your expected operating temperatures.

			I
colder <	40°F	......	> warmer J
Synthetic 5W-30	I	SAE 30	I
Synthetic 5W-30	I	SAE 30

Although multi-viscosity oils (5W30, 10W30, etc.) improve starting in cold weather, these multi-viscosity oils will result in increased 011consumption when used above 40°E Check your engine oil level more frequently to avoid possible damage from running low on oil. Oi_ sump capacity is 20 ounces.

Gasoline

Your pressure washer engine is 4 cycle. Use unleaded fuel only.

&AlwaysCAUTION:allow Doroomnot foroverfillfuel expansionthe fuel tank. .

	avoid	explosion and injury, never fill fuel tank							I
	when	engine	is running		or hot. Do not smoke
,	ARNING:		Never	fill	fuel	tank	indoors.	To
	or have open		flame	when		filling	fuel tank.

{_90 A_ o _oo

8-ENG