Usethewireincludedinthekitor a small paper

Usethewireincludedinthekitor a small paper

clip to free the foreign materials clogging or restricting the nozzle.

Insert wire into nozzle and turn back and forth to clear obstruction.

Parts in the O-Ring ICJtInclude:

•1 O-ring,red, (p/n B2726) for the end of the spray

gun connection between gun and highJ1owspray wand.

Remove additional debris by back flushing water

supply through wand. Back flush between"30 to 60 seconds. Turn wand to stream spray and move nozzle from low to high pressure while flushing.

•Reinstall nozzle into wand. DO NOT overtighten.

•Reconnect wand extension to spray gun.

•Reconnect the water supply, rum ON the water, and start the engine.

•Test the cleaning system by operating with nozzle in the high and the low pressure positions.

O-Ring Maintenance

Through the normal operation of your cleaning

system, the o-rings keep the connections of the hoses and gun tight and leak-free. They may become worn or damaged with use. Provided with your cleaning system is an O---ring Maintenance Kit containing replacement o-rings, a rubber washer and a garden hose inlet screen.

•2 O-rings, yellow, (p/n B2264) for the ends of the high pressure hose.

Note: The above two o-rings are close in size. Please match carefully to assure proper o--,ring

usage.

•1 rubber washer (p/n B2385) for the inside of the garden hose connector.

•1 water inlet screen (p/n B2384) for the garden hose connector.

To remove a worn or damaged O-Ring:

•Use a small flathead screwdriver to get undemeath the o-ringand pry it off.