To Start the Cleaning System, Choke Position

Toaddfueltoengine:

•Clean area around fuel cap, remove cap.

•Add regular unleaded gasoline, slowly, to the fuel tank.

Important: Never mix oil with gasoline.

•Install fuel cap and wipe up any spilled gasoline.

TO START THE CLEANING SYSTEM

The best way to start your cleaning system engine for the first time is to follow these instructionsstep-by- step. This starting information also applies whenever

you start the engine after you have let the cleaning system sit idle for at least a day.

•Place the cleaning system in an area close enough

to an outside water source that can flow at ;_ rate of at least 3 gallons per minute. Connect a garden hose to the water spout.

•Check that the high pressure hose is tightly

connected to the spray gun and to the pump. See ASSEMBLY section on page/4.

•Check inlet screen on the water inlet. If the screen is dirty, clean before attaching a garden hose. If the screen is damaged, do not connect to the garden hose. Replace with screen provided in maintenance

kit or call 1-800-366-PART to order a replacement inlet screen.

•Attach the the garden hose to the water inlet.

•Tum on the water.

Important: Do not run pump without the water supply connected and turned on. You must follow this

caution or the pump will be damaged.

•Remove the adjustable nozzle extension from the spray gun.

•Pull the trigger on the spray gun and hold until a steady stream of water appears.

•Engage the safety latch on the spray gun.

Safety Latch

•Attach adjustable nozzle extension onto spray gun.

•Pull choke lever all the way out to the =FULL

CHOKE POSITION."

Choke Lever

in =Full Choke

Position"

Note: If restarting a warm engine after a short shutdown, move choke lever to =NO CHOKE PosmoN."

•Move Run/Stop switch to the "1" or on position.