USE OF THE PERSONAL BACK
The Personal Back includes a movable foam lumbar and left and right foam laterals attached to the back shell with hook and loop fasteners to provide additional positioning capability. To access the lumbar and the laterals, unzip the cover and push the foam forward, away from the back of the shell. The lumbar and later- als will then be accessible for making adjustments.
PERSONAL BACK/PERSONAL BACK PLUS INSTALLATION (FIGURE 5)
WARNING
The position of the Personal Back in the three
(3)different mounting bracket slots is directly related to the chair's stability. When the Per- sonal Back is added to a TILT and/or RECLIN- ING chair, it may cause a decrease in the chair's stability. It may be necessary to repo- sition the FRONT CASTERS, REAR WHEELS, BACK ANGLE,
1.Install the Personal Back onto the mounting plate so that the upper studs locate into the appropriate slots.
2.Turn bottom mounting pin until tear drop aligns with mounting hole.
3.Install bottom mounting pins into one (1) of the three
(3) sets of tear drop holes in the bottom of the mount- ing bracket.
4.To lock, rotate the mounting pins to the downward position.
WARNING
Make sure hook and loop straps are se- curely holding the levers. The Personal Back may come loose if the levers are not locked down.
5.Secure mounting pins from rotating with hook and loop straps on back of cover.
6.To remove the Personal Back, reverse STEPS
NOTE: Mark the upper and lower mounting positions of the Personal Back mounting bracket for reference by fam- ily or caregivers.
Stud
Mounting
Bracket
Hook and
Loop Strap
Mounting
Hole
Mounting Pin 
Push and Turn to
Release Back
FIGURE 5 - PERSONAL BACK/PERSONAL BACK
PLUS INSTALLATION
Headrest Installation
Headrests may be installed on the Personal Back. The Headrest Reinforcement Plate MUST be used and is available separately.
PERSONAL BACK MAINTENANCE
WARNING
DO NOT continue to use this product if problems are discovered. Corrective maintenance can be performed at or ar- ranged through your equipment supplier.
Cleaning Instructions
BACK ASSEMBLY.
Clean weekly with dampened cloth. Wipe entire surface.
Weekly visual inspection of parts including hardware, brackets, upholstery materials, foams (if accessible), and plastics, for deformation, corrosion, breakage, wear or compression.
Check ALL fasteners weekly to ensure that mechani- cal connections are secure.
USA/UK ENGLISH | 4 |
