Connecting the drain hose
The cable should not be bent or compressed.
GB
65 - 100 cm |
Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor;
The power supply cable must only be replaced by authorised technicians.
Warning! The company shall not be held responsible in the event that these standards are not observed.
The first wash cycle
Once the appliance has been installed, and before you use it for the first time, run a wash cycle with
alternatively, place it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.
detergent and no laundry, using wash cycle number 2.
We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity socket, make sure that:
• the socket is earthed and complies with all |
applicable laws; |
Technical data
Model | PWE 8128 W |
width 59.5 cm
Dimensionsheight 85 cm depth 62 cm
• | the socket is able to withstand the maximum |
power load of the appliance as indicated in the | |
Technical data table (see opposite); | |
• | the power supply voltage falls within the values |
indicated in the Technical data table (see opposite); | |
Capacity
Electrical connections
Water connections
between 1 and 8 kg
please refer to the technical data plate applied to the machine
maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.5 bar)
drum capacity 62 litres
• the socket is compatible with the plug of the |
washing machine. If this is not the case, replace the |
socket or the plug. |
The washing machine must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain, storms and other weather conditions.
When the washing machine has been installed, the electricity socket must remain within easy reach.
Do not use extension cords or multiple sockets.
Spin speed | up to 1200 rpm |
Test wash cycles | wash cycle 2; temperature 60°C; |
in compliance with | performed with a 8 kg load. |
regulation |
|
EN 60456 |
|
This appliance conforms to the following European Community directives:
-89/336/EEC dated 03.05.89 (Electromagnetic Compatibility) and subsequent amendments
-2006/95/EC – 2006/95/EC (Low Voltage)
3