Whirlpool W10136968C Installation clearances, Dryer Dimensions, Closet installation Dryer only

Page 5

A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. If slope is greater than 1" (2.5 cm), install Extended Dryer Feet Kit, Part Number 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level.

For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need 18" (46 cm) to the bottom of the dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Custom undercounter installation - Dryer only

0"

 

 

(0 cm)

 

 

38" min.

 

 

(96.52 cm)

 

 

1"*

27"

1"*

(2.5 cm)

(68.6 cm)

(2.5 cm)

*Required spacing

Closet installation - Dryer only

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

Installation clearances

The location must be large enough to allow the dryer door to open fully.

Dryer Dimensions

52 ⁹⁄₁₆" (133.16 cm)

 

14" max.*

 

(35.6 cm)

 

18" min.*

 

(45.72 cm)

1"*

32⁹⁄₁₆"

5"**

(2.5 cm)(82.65 cm)(12.7 cm)

A

48in.2*

(310 cm2)

24in.2*

(155 cm2)

3"*

(7.6 cm)

3"*

(7.6 cm)

B

38"

(96.52 cm)

*32 ⁹⁄₁₆"

(82.65 cm)27"

(68.6 cm)

*Most installations require a minimum 5" (12.7 cm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

Installation spacing for recessed area or closet installation

The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 0" (0 cm) clearance on the sides and rear. Recommended spacing should be considered for the following reasons:

Additional spacing should be considered for ease of installation and servicing.

Additional clearances might be required for wall, door and floor moldings.

Additional spacing should be considered on all sides of the dryer to reduce noise transfer.

For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

Companion appliance spacing should also be considered.

A. Side view - closet or confined area

B. Closet door with vents

*Required spacing

**For side or bottom venting, 2" (5.1 cm) spacing is allowed.

Recessed or closet installation - Dryer on pedestal

 

 

 

 

14" max.*

 

 

 

 

(35.6 cm)

 

 

 

 

18" min.*

 

 

 

 

(45.72 cm)

1"

27"

1"

1"*

32⁹⁄₁₆"

5"**

(2.5 cm)

(68.6 cm)

(2.5 cm)

(2.5 cm)

(82.65 cm)

(12.7 cm)

AB

A. Recessed area

B. Side view - closet or confined area

*Required spacing

**For side or bottom venting, 2" (5.1 cm) spacing is allowed.

5

Image 5
Contents W10136968C Electronic Electric DryerDryer Safety Table of ContentsIf using a power supply cord Installation InstructionsTools andParts Parts neededLocationRequirements OptionsDryer Dimensions Installation clearancesCustom undercounter installation Dryer only Closet installation Dryer onlyMobile home installations require Recommended installation spacing for cabinet installationMobile home Additional installation requirements ElectricalRequirements If connecting by direct wireIt is your responsibility Electrical ConnectionElectrical Connection Power Supply Cord Direct WireStyle 1 Power supply cord strain relief Style 2 Direct wire strain relief Wire connection Power supply cordRemove center silver-colored terminal block screw Wire connection Direct wireBDE CG F Optional 3-wire connection If this is a new vent system Vent material If using an existing vent systemVentingRequirements Alternate installations for close clearances Optional exhaust installationsSpecial provisions for mobile home installations PlanVentSystemInstall LevelingLegs Install VentSystemVent system chart ConnectVentLevelDryer CompleteInstallationConnectInletHose If the dryer will not start, check the following Dryer USEStartingYourDryer How Automatic Cycles Work To use an Automatic CycleTo use a Manual Cycle To use a Steam CycleStopping YourDryer PausingorRestartingControlLocked DryingandCycleTipsCycles Additional Features DryingRackOption ChangingCycles,Options andModifiersCleaningtheLintScreen CleaningtheDryer LocationCleaningtheDryerInterior Dryer CareWaterInletHoses RemovingAccumulatedLintVacation,StorageandMovingCare ChangingtheDrumLightDryerResults TroubleshootingDryerOperation Lint on load Cycle time too shortStains on load or drum Loads are wrinkledAccessories W10136968C Call