INSTALLATION INSTRUCTIONS
Tools and Parts
Tools needed
Gather the required tools and parts before starting installation. Read and follow the safety instructions provided with any tools listed here.
■ | ■ | Caulking gun and | |
■ | Level |
| compound (for installing |
| new exhaust vent) | ||
| Adjustable wrench |
| |
■ | ■ | Tin snips (new vent | |
| Vent clamps | ||
■ |
| installations) |
Parts supplied
Remove parts package from the dryer drum. Check that all parts listed are included.
■ | 1 | - Cycle Control (timer) | ■ | 2 | - Cord brackets |
|
| knob | ■ | 2 | - Screws |
| 1 | - Push to Start button | |||
■ |
|
|
| ||
■ | 4 | - Casters |
|
|
|
Parts needed
Check local codes, existing electrical supply and venting, and see “Venting Requirements” and “Electrical Requirements” before purchasing parts.
■Mobile home installations require metal exhaust system hardware
■Permanent installations require 4 dryer feet
For ordering information, please reference the “Assistance or Service” section of this manual. You can also contact the dealer from whom you purchased your dryer.
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
You will need
■A location that allows for proper exhaust installation. See “Venting Requirements.”
■A
■A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See “Electrical Requirements.”
■A sturdy floor to support the dryer weight (dryer and load) of 115 lbs (52 kg). The combined weight of a companion appliance should also be considered.
■A level floor with a maximum slope of 1" (2.5 cm) under entire dryer.
Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
Installation Clearances
The location must be large enough to allow the dryer door to open fully.
4