Whirlpool 8178023 manual Cool Down, Wrinkle Shield, Sales Demonstration Mode

Cool Down

The time-based cool down time for automatic cycles varies from two to ten min- utes, depending on the load size, moisture content, and dryness level selected. For timed cycles, the cool down time depends on the total drying time the user selects.

Wrinkle Shield

The WRINKLE SHIELD action tumbles the load without heat for 10 seconds of every 5 minutes after the drying cycle is complete. WRINKLE SHIELD will con- tinue for a maximum of 120 minutes (2 hours). If the door is opened and the PAUSE/CANCEL key is pressed once, the control will enter the pause mode and pressing the START key with the door closed will restart the WRINKLE SHIELD operation. If the 120 minute time limit expires, the WRINKLE SHIELD action termi- nates, the CYCLE SIGNAL is then sounded, (if selected), and the control removes power from the motor and LEDs. Pressing the WRINKLE SHIELD key while in WRINKLE SHIELD mode also terminates WRINKLE SHIELD. In essence, dese- lecting WRINKLE SHIELD after the main cycle has completed simply turns the dryer off.

SALES DEMONSTRATION MODE

The “Sales Demonstration Mode” allows sales personnel to quickly demonstrate the cycles and options on the sales floor. The mode consists of an embedded software routine which resides in the main dryer program which is defined as fol- lows:

1.Open the dryer door.

2.Press the Touch Up cycle.

3.Select Air Only temperature.

4.Press Wrinkle Shield.

5.Press Start.

The sequence of operation is as follows:

•The Sensing LED turns on for 5 seconds and then turns off.

•The Wet LED turns on for 5 seconds and then turns off.

•The Damp LED turns on for 5 seconds and then turns off.

•The Drying & Cool Down LED turns on for 5 seconds and then turns off.

•The Cycle Complete and Wrinkle Shield LEDs turn on, and the End-Of-Cycle signal sounds at the selected level.

Terminate the Sales Demonstration mode by pressing the Stop/Cancel keypad.

2