Whirlpool GEW9250PL0, GEW9250PW0 Dryer Care, CleaningtheDryer Location, CleaningtheLintScreen

Page 22

DRYER CARE

CleaningtheDryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

CleaningtheLintScreen

Every load cleaning

The lint screen is located in the door opening of the dryer. The control panel has an indicator light to remind you to clean the lint screen before or after each load. A screen blocked by lint can increase drying time.

To clean

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements.”

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

CleaningtheDryerInterior

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

Apply a liquid, nonflammable household cleaner to the stained area and rub with a soft cloth until all excess dye and stains are removed.

3.Wipe drum thoroughly with a damp cloth.

4.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid dye transfer.

RemovingAccumulatedLint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

22

Image 22
Contents Electronic Electric Dryer 8577193Table of Contents Dryer Safety Your safety and the safety of others are very importantToolsandParts Installation InstructionsOptions Location Requirements Installation clearancesDryer Dimensions You will needMobile home installations require Minimum installation spacing for cabinet installationMobile home Additional installation requirements Recessed or closet installation Dryer on pedestalIt is your responsibility ElectricalRequirementsElectrical Connection Style 1 Power supply cord strain relief Power Supply Cord Direct WireElectrical Connection Wire connection Power supply cord Style 2 Direct wire strain reliefWire connection Direct wire Remove center silver-colored terminal block screwBDE CG F Optional 3-wire connection VentingRequirements If using an existing vent systemIf this is a new vent system Vent material Alternate installations for close clearances Optional exhaust installationsPlan VentSystem Vent system chart Install VentSystemSpecial provisions for mobile home installations Determine vent pathLevelDryer Install LevelingLegsCompleteInstallation ConnectVentStartingYourDryer Dryer USETo use an Automatic Cycle ControlLocked PausingorRestartingStoppingYourDryer DryingandCycleTipsStatusLights CyclesAdditional Features End of Cycle Signal DryingRackCleaningtheDryerInterior CleaningtheDryer LocationCleaningtheLintScreen Dryer CareVacationandMovingCare ChangingtheDrumLightTroubleshooting DryerOperationStains on load or drum Cycle time too shortLint on load Loads are wrinkledFor assistance and service Assistance or ServiceIf you need replacement parts Accessories U.S.APage Whirlpool Corporation will not pay for Whirlpool Dryer Warranty8577193