Whirlpool 3406449 installation instructions Outside dryer

4 . Attach 3/4” U.L.- listed strain relief (U.L. marking on strain relief) to the hole below terminal box opening (see Figure 12). Tighten strain relief firmly to cabinet so it is in a horizontal position. Place direct wire cable through the strain relief.

(outside dryer)

Figure 12

B.

Where local codes permit connecting frame-ground conductor to the neutral wire:

This dryer is manufactured with the

3 . Attach 3/4” U.L.-listed strain relief (U.L. marking on strain relief) to the hole below terminal box opening (see Figure 15). Tighten strain relief firmly to cabinet so it is in a horizontal position. Place power supply cord through strain relief.

,i$ 5 . Remove the center terminal

..!,!!,: block screw, Remove the neutral

,Y::.-:.i: green with yellow stripe ground wire

.i! - ‘!: from external ground conductor

j ;,; screw. Connect neutral green with

.. !: yellow stripe ground wire and the ;.;.j..; neutral wire (white or center) of $j ! direct wire cable under the center $I:‘:.:screw of terminal block. Place the $;i:i:i.hook-shaped end of the wire over :.$$<the terminal block screw with open ‘:$:.: side of the hook facing to the right. Ii:; i Squeeze hook end of wire together !.I ; to form a loop.

Z$.iij Connect the other two insulated ;:;si..iwires under outer terminal block

I:i. screws. Attach wires using the same $ ;.I method as the neutral wire.

...j;..$;; Connect the direct wire cable (bare f; :; ground wire to the external ground

:1 conductor screw (see Figure 13).

.: i. Tighten all terminal block screws

:,; j : firmly.

	neutral	green with	yellow
~; zjexternal	stripes	(attached	at
	factory)

frame-ground conductor connected to the NEUTRAL (center) of the wiring harness at the terminal block. If local codes do Not permit this type of connection, use “Four-wire

connection” instructions.

Electrical Shock Hazard

Turn power supply off before

connecting cord.

rounded outlet.

1 . Turn power supply off.

2 . Remove hold-down screw and terminal block cover.

hold-

external ground

strhin relief (outside dryer)

Figure 15

#i: 4 . Loosen or remove terminal

:: block screws. Connect the neutral

::

: : wire (white or center) of power

:1 supply cord under the center screw :.j

:; ,; of the terminal block.

’,: : Connect the other two wires to

:: :: outer terminal block screws (see

:: :j: : Figure 16).

:: : Tighten all terminal block screws

j : firmly,

:: :: Center wire MUST be connected to

:: c center screw.

::..::

: :
: :	external ground
: :
: :
: :

:c

::

: :

! :

strain relief screws

Figure 16

Figure 13

strain relief screws.

. Insert tab of terminal block :.i :I. cover into slot of the dryer rear

i’ ‘$. panel (see Figure 1 1). Secure cover /z...-::i. with hold-down screw.

i.5 . Tighten strain relief screws.

6 . Insert tab of terminal block

:cover into slot of the dryer rear

panel (see Figure 14). Secure cover

:: with hold-down screw.

::

::::: ::

:

Page 8