KH2400
Steam ironing
Unwind the mains lead. Ensure that the iron is disconnected from the power sup- ply before you fill it with water. Turn steam regulator to the dry position (0 position) and the temperature control knob to MIN.
Fill the iron with water. Ensure that the MAX marking line is not exceeded. Con- nect the appliance to the mains power supply again. The blue
Set the temperature control knob to the steam position 
and the heating light will illuminate. In this setting, the iron can be used as a steam iron once the heating light goes out. The heating light will illuminate and go out regularly during ironing as an indi- cation that the temperature control is working properly.
Setting the knob
You can adjust the steam easily with the 7 positions of the steam control gear. Put the iron on the heel rest when rear- ranging clothing or while not in use. Steaming stops when the iron is placed on the heel rest.
Using the steam burst button
Be sure there is water in the tank | and |
the temperature control knob | is on |
steam. |
|
Using the iron horizontally |
|
Lift the iron and press the steam burst
button | . You may need to press this |
button | a few times after filling the |
iron with water to activate the pump. The burst steam facility can be used only when ironing at temperature of at least 150° C, this means form III to MAX.
Turn the steam control gear to the | Using the iron vertically |
steam position and the iron will create |
|
steam. Turn the steam control gear to |
|
the position 0, and the steam will cease. |
|
Steam adjustable |
|
- 8 - |