Problem solving guide
Any work done on the electrical components of this appliance should only be performed by a qualified and trained person in accordance with all local and national codes and regulations. Unauthorized repairs may result in personal injury and damage to the machine.
What to do if, . . . | Cause . . . | Remedy . . . |
|
|
|
. . . The programme does not | There is no power. | Check that..: |
start? | The “ON” indicator lamp has | – the door is properly closed. |
| not lit up. | – the machine is plugged in. |
|
| |
|
| – the fuse or circuit breaker |
|
| has not tripped. |
| There is power and the “ON” | – Turn the programme selector |
| indicator lamp is on, but the | to the “Start/Finish” position. |
| programme selector has not | – Select a programme. |
| been turned to the “Start/Finish” |
|
| position. |
|
|
|
|
. . . The “Check p / q” indi- | The “Check p” indicator lamp | – The inlet valve is not opened |
cator lamps are flashing? | is flashing, and the programme | far enough. |
| has started. | – The inlet hose is kinked. |
| The water inlet is blocked. | – The water pressure is too |
|
| |
|
| low. Call the Service Dept. |
|
|
|
| The “Check q” indicator lamp | – Clean the drain pump and |
| is flashing. | lint trap. |
| The drain is blocked. | – Has the drain hose been |
|
| installed too high? (max drain |
|
| height = 4 feet) |
|
|
|
31