Problem solving guide
What to do if, . . . | Cause . . . | Remedy . . . |
|
|
|
. . . the | There is an internal problem. | Restart the programme. If the |
wash” or “Rinse |
| indicator lamp starts flashing |
tor lamp is flashing? |
| again, call the Service Dept. |
|
|
|
. . . The “Rinse & hold” indi- | The spin speed setting has | Select a spin speed setting. |
cator lamp is flashing? | been set to “Without final spin”. |
|
|
|
|
. . . The “Final spin” indica- | The final spin has not taken | – Redistribute the laundry load. |
tor lamp is flashing? | place. The machine detected | – Select a spin speed. |
| an imbalance. | – Turn the programme selector |
|
| |
|
| to “Spin”. |
|
|
|
. . . The “ON” indicator lamp | The | Go back to the programme |
is flashing? | activated, and the programme | originally selected. |
| has been changed. |
|
. . . The wash is too wet after | The spin speed selected was | Select a higher spin speed next |
the final spin? | too low. | time. |
| The load was not evenly | Mix large and small items in a |
| distributed in the drum, and the | load to avoid imbalance. |
| laundry was spun at a reduced |
|
| speed to protect the machine. |
|
|
|
|
| The drain pump or lint trap is | Clean the drain pump or lint |
| clogged. | trap. |
|
|
|
. . . The machine shakes dur- | The four feet are not resting | Level the machine (see |
ing the spin cycle? | evenly on the floor. | Installation Section). |
| The shipping struts have not | Remove the shipping struts. |
| been removed. |
|
|
|
|
32