Miele T 8019 C Installing the drain hose sink, gully, Special Installation

Installation

Installing the drain hose (sink, gully)

^See illustration, front view.

,If you want to drain the condensed water into a sink, secure the hose carefully, e.g. by tying the hose to the water faucet, to avoid water damage.

^Use the curved guide to prevent the drain hose from becoming kinked (see "Front view" illustration).

Special Installation

,In special installation circumstances, the non-return valve must be installed. Water flowing back from the dryer can cause damage.

Special Installations are:

–Connection to a sink standpipe (see example)

–Miscellaneous connections where additional appliances like a washer or dishwasher are connected also.

Example: Connection to a standpipe

The drain hose can be connected to a special sink standpipe.

^Remove the adapter and the hose clamp from behind from the lower rear side of the dryer.

1 Adapter

2Sink coupling nut

3Hose clamp

4Hose extension (Accessory)

5Non-return valve (Accessory)

6Dryer drain hose

^Fit the adapter, 1, to the stand pipe using nut, 2. If this nut is sealed with a flat disc, take the disc out.

^Attach the end of the hose to the adap- ter 1 and secure the hose clamp 3.

,The non-return valve 5 must be installed with the arrow pointing in the direction of the water flow (see illustration), otherwise it will not work properly.

^Install the non-return valve 5 at the dryer drain hose 6, see illustration.

^Secure the non-return valve firmly with the hose clamp (accessory).

36