Miele T 9820 Program end Unload the laundry, Changing a running program, To cancel a program

Page 16

Use

6.Program end - Unload the laundry

The "Anti-crease/End" indicator will light at the end of the program and the buzzer will sound if it was selected.

The indicator of the reached drying degree lights (depending on program).

To avoid wrinkles, the drum turns in intervals for up to one hour, if the laundry is not immediately removed (Anti-crease).

^Open the door.

If the door remains open, the light goes off after a few minutes (saving energy).

^Remove the laundry.

,Check the drum for any missed pieces of laundry. Any items left in the dryer may be damaged because of over drying.

^Clean the lint filter after each use (see "Dryer care").

,Take care when inserting the lint filter not to hurt your fingers.

^Insert the lint filter with the yellow handle edge towards the drum.

^Close the door.

Changing a running program

A running program cannot be changed (protection from accidental changes).

To select a different program the running program must be canceled.

To cancel a program

^Press the "Start/Stop" button.

The laundry will be cooled in case a certain drying time and temperature were reached.

If you press the "Start/Stop" button again during the cooling phase, the "Anti-crease/End" indicator lights.

^Open and close the door.

^Select the new program.

Adding/removing laundry during a drying program

^Open the door.

,Do not touch the rear of the drum while adding or removing items! Danger of burns.

^Add or remove items.

^Close the door.

^Press the "Start/Stop" button.

16

Image 16

Contents Operating Instructions for the T 9820 Gas Dryer Page What to do if YOU Smell GAS Contents Important Safety Instructions ~ Grounding Instructions Using accessories Control panel AProgram buttonsBOptions buttons EStart/Stop buttonFirst use Fabric care labels Before loading the dryerDrying tips Use Sort the laundryLoad the laundry Without the laundry basketWith laundry basket Select a program Close the doorSelect an option TurboGentle BuzzerStart the program Before the end of a programTo cancel a program Program end Unload the laundryChanging a running program Adding/removing laundry during a drying programQuick Guide Remove this guide for easy referenceQuick Guide Prepare and sort the laundryLoad the laundry With the laundry basketSelect an option Select a programStarting a program Program end Unload the laundry Short program guide Hand iron Rotary ironProgram guide Normal loadFrequently asked questions General problemsDrying program cannot be started Possible fault Solution Lint has built-up on laundryLaundry is still wet. The program runs too long Laundry is not dry enough Possible fault SolutionDrum light does not come on Fault indicators Check Filter/Vent indicator lights Possible fault SolutionProgram is canceled Check Filter/Vent indicator flashes Dryer is making a thumping or grinding soundLaundry is pressed on the door and below the door After sales service Optional accessoriesRepairs MieleCarePage User Maintenance Instructions Dryer Care Cleaning the lint filterRinsing the lint filter Cleaning the exterior and the control panel Changing the light bulb Disposal of the packing materials Caring for the environmentDisposal of an appliance Page