Miele T 1565 C operating instructions Connecting to an external drain

Page 24

Installation

Connecting to an external drain

The condensed water can be drained directly if the machine is installed near a sink or drain outlet.

The machine is equipped with a non-re- turn valve as standard to prevent water from flowing back into the machine (eg. if the machine is connected to a siphon).

Max. drain hose length: (3.0 m) 10 ft

Max. drain height: (1.0 m) 4 ft.

Accessories supplied:

-(2 m) 6 ft drain hose

-Hose clamp

-Hose elbow

Loosen the hose clamp from the drain outlet at the lower left rear of the machine and remove the rubber plug.

Remove the clamp from the plug and place it over the drain hose.

Push the drain hose onto the drain outlet. Make sure that the hose is firmly secured by the hose clamp and not kinked.

24

Image 24
Contents T 1565 C Condenser Dryer Contents Guide to the machine Indicator lamps PushbuttonsImportant Safety Instructions Important Safety Instructions Your contribution to the environment Disposal of the packing ma- terialDisposal of your old machine Loading the machine Unloading the machineFollowing fabrics should not be dried in a tumble dryer Program selection Correct procedure Program is cancelled ifTo select a program To change a program during dryingPrograms CottonsPrograms Do not drink the condensed water Cleaning and care Cleaning the lint filtersCleaning the dryer Cleaning the heat exchanger Cleaning and care Problem solving guide What to do if, . . . ? Cause RemedyCorrecting minor faults Problem solving guideTo open the door in the event of a power failure After-sales service SpecimenGrounding instructions Electrical connectionThis appliance must be grounded Installation Where to install the machineConnecting to an external drain Installation Consumption data CottonsPermanent Press Technical data