Program selection
To select a program
A program can only be selected when the machine is turned on.
Set the desired program by turning the program selector either clock- wise or counterclockwise.
Press the “Start” button.
The program status will be stored for 30 minutes in the event of a power failure.
The program is cancelled if:
–There is a power failure lasting more than 30 minutes.
–The program has already reached the “Cooling down” or
To change a program during drying:
Set the program selector to the desired program.
The new program will start from the be- ginning.
The tables following on the next two pages list the range of applications for the different programs.
Correct procedure:
1Press the “On/Off” button.
2Press the “Door” button and load the drum.
3Close the door with a firm swing - do not push it shut.
4Select “Low temp.” and “Buzzer” if so desired.
5Select a program.
6Press the “Start” button.
After the program has finished:
1Set the program selector to “Finish”.
2Remove the laundry.
3Clean the lint filter.
4Turn off the machine.
5Empty the condensed water con- tainer.
(Omit this step if dryer has been set up for external drainage of con- densed water)
11