G. Fixed Glass Assembly
Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Removing Fixed Glass Assembly
•Pull the four glass assembly latches out of the groove on the glass frame. Remove glass door from the appli- ance. See Figure 14.5.
Replacing Fixed Glass Assembly
•Replace the glass door on the appliance. Pull out and latch the four glass assembly latches into the groove on the glass frame.
LATCHES |
(BOTH BOTTOM |
AND TOP) |
GLASS |
ASSEMBLY |
Figure 14.5 Fixed Glass Assembly |
H. Install Louvers and Trim
•Install optional trim kits and/or surrounds using the instructions included with the accessory.
•Use
I. Install Hood
See Figure 14.6.
DETAIL A
HOOD CLIPS LOCATED ABOVE GLASS FRAME.
SEE DETAIL A.
Figure 14.6 Install Hood
J. Air Shutter Setting
Air shutter settings should be adjusted by a qualified in- staller at the time of installation. The air shutter is set at the factory for minimum vertical vent run. Adjust air shut- ter for longer vertical runs.
NOTICE: If sooting occurs, provide more air by opening the air shutter.
Air Shutter Settings
Models | NG | LP |
| |
DV3732SBI | 1/8 in. | 1/2 in. | | |
DV3732SBIL | ||||
|
|
|
62 | Hearth & Home Technologies • DV3732SBI, DV3732SBIL • |
