Miele T 1302 What if the dryer will not run?, How do I prevent static cling?

Page 17

	Frequently asked questions


What if the dryer will not run?
Possible fault	Fix
The "Start/Stop T" button was not	Make sure the dryer is on. Press the "Start/
pressed.	Stop T" button to begin the drying program.

The circuit breaker tripped or the	Make sure the dryer is plugged in or reset
dryer is unplugged.	the circuit breaker.

The door is not closed.	Close the door properly.

How do I prevent static cling?

Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer.

What if the drum light does not come on?

Possible fault

Fix

The bulb may be bad or burned See "Changing the light bulb." out.

What if the "Child Lock" indicator flashes after turning the dryer on and a program cannot be started?

Possible fault	Fix

The child lock is activated.	Deactivate the child lock. See "Child Lock."

What if the program stops, the "Anti-crease / End" indicator lights and the buzzer sounds?

Possible fault	Fix

The drum is empty.	Load laundry into the dryer. The dryer will not
	operate when the drum is empty. Single
	items should be dried with "Sturdy" or a
	timed program and dry items in the "Fluff"
	program.

What if the "Filter/Vent" fault indicator is lit?
Possible fault	Fix

The lint filter is clogged.	Clean the lint filters. See "Dryer care".

The exhaust hose or the	Remove lint and check the exhaust system
connection is clogged with lint.	for blockages.

The air supply in the room is	Open a window or door to increase airflow.
insufficient.

17

Image 17

Contents Operating Instructions Vented Dryer 1302 Contents This dryer is intended for residential use only Important Safety InstructionsImportant Safety Instructions Control panel Program recommendations Before loading the dryerSelect a program Using the dryerTurn on the dryer and load the laundry Extra Dry Program When to useTurbo Select a drying option if neededFull load GentleSelect the buzzer if desired Adjusting the buzzer volumeSelect the dryness level At the end of a program Start the programAdding or removing laundry during a program Canceling or changing a programChild lock Child lockTo activate the child lock To deactivate the child lockDryer care Cleaning the lint filterCleaning the drum Cleaning the exterior and the control panelChanging the light bulb What if the dryer will not run? What if the Filter/Vent fault indicator is lit?How do I prevent static cling? What if the drum light does not come on?What if the program runs too long or stops? Frequently asked questionsWhat if the laundry is not dry enough? What if water has collected around the drum opening?Quick Guide Turn on the dryer and load the laundry Quick GuideSelect a program Select a drying option if neededAt the end of a program Select the dryness levelSelect the buzzer if desired Start the program For uniform loads, e.g. sheets Underwear, socks PC Update Technical ServicePage Installation Instructions Important Safety Instructions Disposal of an appliance Caring for the environmentDisposal of the packing materials Washer / Dryer Stack Height of vent adapter in a stacked installationElectrical connection Easy Installation KITInstallation Leveling the dryer InstallationChanging the position of the exhaust connection Determining the position of the exhaust connectionAdapter Installation tipsFlexible exhaust hose or rigid Pipe Exhaust connection with aWindow connection Wall connection with rigid pipeDryer top view Direct wall connectionTips about the ductwork How to calculate the effective duct lengthElbow 90 sharp Smooth metal ductConcertina bend Wall vent or window ventTotal duct length Page All rights reserved