Miele T 1302 Exhaust connection with a, Flexible exhaust hose or rigid Pipe, Window connection

Page 34

Installation

Exhaust connection with a

Window connection

flexible exhaust hose or rigid

 

 

pipe

 

Using the connector supplied, an exhaust hose (4" [100 mm] diameter) can be installed.

Necessary materials:

– a wall or window duct

– an exhaust hose made of approved non-flammable material

1 Window connection (installed in a plexiglass pane)

2 Connector for the flexible exhaust hose

Wall connection with rigid pipe

^If the duct length is more than 33 ft (10 m), remove the ring adapter, 1, from the connector, 2. If the duct

length is less than 33 ft (10 m), leave the ring adapter in to improve time and energy efficiency.

^ Install the connector, 2, with the exhaust hose or pipe, 3, to the dryer.

1 Wall pipe

2 Connector

3 Rigid pipe

30

Image 34
Contents Operating Instructions Vented Dryer 1302 Contents Important Safety Instructions This dryer is intended for residential use onlyImportant Safety Instructions Control panel Before loading the dryer Program recommendationsTurn on the dryer and load the laundry Using the dryerSelect a program Program When to use Extra DryFull load Select a drying option if neededTurbo GentleSelect the dryness level Adjusting the buzzer volumeSelect the buzzer if desired Start the program At the end of a programCanceling or changing a program Adding or removing laundry during a programTo activate the child lock Child lockChild lock To deactivate the child lockCleaning the lint filter Dryer careCleaning the exterior and the control panel Cleaning the drumChanging the light bulb How do I prevent static cling? What if the Filter/Vent fault indicator is lit?What if the dryer will not run? What if the drum light does not come on?What if the laundry is not dry enough? Frequently asked questionsWhat if the program runs too long or stops? What if water has collected around the drum opening?Quick Guide Select a program Quick GuideTurn on the dryer and load the laundry Select a drying option if neededSelect the buzzer if desired Start the program Select the dryness levelAt the end of a program For uniform loads, e.g. sheets Underwear, socks Technical Service PC UpdatePage Installation Instructions Important Safety Instructions Disposal of the packing materials Caring for the environmentDisposal of an appliance Height of vent adapter in a stacked installation Washer / Dryer StackEasy Installation KIT Electrical connectionInstallation Installation Leveling the dryerDetermining the position of the exhaust connection Changing the position of the exhaust connectionInstallation tips AdapterWindow connection Exhaust connection with aFlexible exhaust hose or rigid Pipe Wall connection with rigid pipeDirect wall connection Dryer top viewHow to calculate the effective duct length Tips about the ductworkConcertina bend Smooth metal ductElbow 90 sharp Wall vent or window ventTotal duct length Page All rights reserved