Important Precautions, Assembly Instructions

IMPORTANT PRECAUTIONS – continued

•Water hose must be at least 3/4 inch in diameter.

•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).

•Flow rate can be determined by running the water for one minute into an empty 5-gallon container.

•The water supply temperature must not exceed 104°F/40°C.

•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.

•Always prevent debris from being drawn into the unit by using a clean water source.

You will need a standard screw driver OR a Torx T-25 screw driver

Step 1 Attach the mobile adapter brackets to the pressure washer. Align holes on the bottom of the pressure washer as shown and tighten the 4 screws.

Step 2 Spread handle sides apart and align with slotted areas of mobile adapter brackets and snap into position. Tighten the 4 screws.

Step 3 Slide the hose caddy into the handle slots and snap into place.

Step 4 Slide the spray wand extension into the gun. Turn the wand collar clockwise onto the gun threads until tight.