40000133.qxd
Trouble shooting
Trouble shooting
Should your dryer operate incorrectly, check the following points before calling for a service engineer.
Drying time is too long/clothes are not dry enough:
●Have you selected the correct drying time/programme? Go to page 9.
●Were the clothes too wet? Were the clothes thoroughly wrung or
●Does the filter need cleaning? Go to page 6.
●Does the condenser need cleaning? Go to page 7.
●Is the dryer overloaded? Go to page 4.
●Are the inlets, outlets and base of the dryer free from obstructions?
●Has the ‘HEAT SETTING’ button been selected from a previous cycle? Go to page 9.
The dryer does not operate:
●Is there a working electricity supply to the dryer? Check using another appliance such as a table lamp.
●Is the plug properly connected to the mains supply?
●Is there a power failure?
●Has the fuse blown?
●Is the door fully closed? Go to page 9
●Is the dryer switched on, both at the mains supply and at the machine? Go to page 9.
●Has the drying time or the programme been selected? Go to page 9.
●Has the machine been switched on again after opening the door? Go to page 5.
●Has the dryer stopped operating because the water tray is full and needs emptying? Go to page 6.
The dryer is noisy
●Switch off the dryer and contact the Hoover service number 08705 400 600 for advice.
Filter Care Indicator on
●Does the filter need cleaning? Go to page 6.
●Does the condenser need cleaning? Go to page 7.
Empty Water Indicator on
●Does the water container need emptying? Go to page 6.
If the supply cord on this appliance is damaged, it must be replaced by a special cord which is only available from Hoover Service or an authorised Hoover Dealer.
Should there still be a problem with your dryer after completing all the recommended checks, please call the national Hoover Service number 08705 400 600
(Eire - 018301 666) for advice. They may be able to assist you over the telephone or arrange for a suitable appointment for an engineer to call under the terms of your guarantee. However, a charge may be made if any of the following applies to your machine:
●Is found to be in working order.
●Has not been installed in accordance with the installation instructions.
●Has been used incorrectly.
11